Had a plugged cigar today and it was really frustrating. Looked at some draw tools and found perfecdraw. Anyone have any experience with them? Figured I would check in before making a purchase.
[Reply]

We have one at the shop. You need to be careful not to split the cigar with it.
[Reply]

I have tried several draw tools over the years and none of them have worked well, but the PerfecDraw works for me. Bought one a couple of months ago and have saved a number of cigars that were too tight to smoke. :-)
[Reply]

:-)

Its the best. You can grind out the bad spot. Watched a brother unplug a 33 rg cigar perfectly.
[Reply]

I have two friends that swear by their Perfect Draws
[Reply]

https://www.hwiebe.com/store/c10/Cigar_Accessories.html
[Reply]

I have a redeemer and love it
[Reply]

Except when it bends huh? :-)


PerfecDraw is the only way to go! Although you don't get the cool little box with the magnetic lid anymore, they swapped over to just cardboard. One really good cigar and this thing pays for itself and it's payed for itself time and again for me, it's also great for lanceros!
[Reply]

That Guy gifted me one recently, and it's by far the best draw tool I have ever used.
[Reply]

I am the undisputed king of draw tool utilization and the perfecdraw is the best draw tool in the universe.

/thread

Hahaha... seriously, though, this thing really is a spectacular draw tool
[Reply]

Thanks for the advice to all in this thread. Just ordered a PerfecDraw
[Reply]

Hmmmm...would it work on a plugged COLA?...say from '01....:-)
[Reply]

I wish I could find the photo from the herf at Groog's place 5-6 years ago (longer?) where you and Grant were using a cordless drill and 10" bit to save a tent peg of a cigar.
[Reply]

Add me to the list. You have two choices - perfecdraw or pitch the cigar.
[Reply]

I'm sold on the perfect draw. Like many, Adam gifted me one and I finally put down my Henry's tool, which I have used for about 15 years.
[Reply]

I use a 1/16" drill bit -- manually, no drill motor:

https://www.amazon.com/Bosch-BL2631-...ts+1%2F16+inch

It works really well because it actually makes a hole by removing bits and pieces. I wrapped some duct tape around the end to make it a little easier to grip.

They are inexpensive!
[Reply]

Yes yes it would! But the last few I have smoked have been fine ... so I don't know if i should hope one is plugged or not :-)

I know Goatlocker loves his and he was actually a bit let down when an old crusty cigar he was going to smoke WASN'T plugged. :-)
[Reply]

Just Ordered One!:-):-):-):-)
[Reply]

:-)... You must be doing much better if you're posting here:-)
[Reply]

Guess I'm adding a PerfecDraw to my shopping list.
[Reply]