If you are I have about 20 extra rubber plugs for the interior drain hole.
Just PM me with your addy and I will send it out to you gratis.
[Reply]

Image
[Reply]

Is this a pic from the inside and did you drill through the cooler? If so, how did that go? From the picture it looks like its only plastic and styrofoam?
[Reply]

Yes from inside. I used the existing punch out from the factory just above the exterior drain hole. I pushed an ice pick through and found just insulation and plastic interior liner. I pushed through the liner to mark the hole and drilled from the interior out. Very easy. I used a 7mm cap nut/Teflon tape on the threads and an o-ring to seal exterior drain. I used the rubber plug to seal the interior drain.


Image
Image
[Reply]

This hole was drilled for the ETC (electronic temperature control)
[Reply]

Think I'll have to go this route as well (ETC), as my edgestar on the warmest setting seems to settle at 58-60.

Any recommendation to a decent ETC sub $100?
[Reply]

I was just looking into the same thing and stumbled upon this looks like it should work
[Reply]

The Ebay one looks like it is made in China. I would recommend this one:
http://www.rancoetc.com/ranco-etc111...ller-p-87.html
[Reply]

Thank you for the plug Joe, much appreciated! How's the activated charcoal working out?
[Reply]

Thanks for the plug Joe! Very kind of you!
[Reply]