Cigar Asylum Cigar Forum Mobile
All Cigar Discussion>can you clip/smoke a cigar witha moldy foot?
loki 10:20 AM 11-02-2008
While recharging beads I found a cigar with a moldy foot...can you clip/smoke when the cigar has mold on the foot? and yes I'm sure it's mold
[Reply]
DBall 10:22 AM 11-02-2008
I've done it on a couple clear havanas... no problems here. If the mold goes back a ways, that could be an issue.
[Reply]
replicant_argent 10:23 AM 11-02-2008
I lopped off a chunk of a partagas de partagas #1 a few weeks back, couldn't tell the difference.

Then again, I have the palate of a goat.
[Reply]
loki 10:29 AM 11-02-2008
I hacked the foot+ a little more off with the old xikar and it seemed to be surface foot mold. I have it in a seperate bag and i'll smoke it later today perhaps
[Reply]
Mugen910 10:42 AM 11-02-2008
I've lopped off a chunk at the end..made sure visually that the rest is ok..and pyro'd that sucka!
[Reply]
loki 11:00 AM 11-02-2008
would proximity to humification promote molding of a cigar? I looked at the other cigars near the beads and none of the other cigars have a problem
[Reply]
Sauer Grapes 12:04 PM 11-02-2008
I can. Also, different kinds of tobacco mold more easily than other kinds. I know that CT Broadleaf Maduro wrappers mold about the easiest.
[Reply]
loki 12:43 PM 11-02-2008
smokin it now tastes fine this cigar in question was a puro ill keep an eye on the humi but the weird thing is the humi is almost always in the low 60s or high 50s rh and mid 60s in temp
[Reply]
Pyro 01:15 PM 11-02-2008
Originally Posted by loki:
...can you clip/smoke when the cigar has mold on the foot?...
As long as the mold is white and the cigar smells ok, no problem!
[Reply]
Da Klugs 01:22 PM 11-02-2008
I microwave them to make sure nuttin is growing in the cigar or in me when I smoke it.
[Reply]
NCRadioMan 01:31 PM 11-02-2008
Originally Posted by loki:
smokin it now tastes fine this cigar in question was a puro ill keep an eye on the humi but the weird thing is the humi is almost always in the low 60s or high 50s rh and mid 60s in temp
Could it have always been there and you just missed it, Kevin? Mold cannot grow at those rh %'s.
[Reply]
md4958 01:53 PM 11-02-2008
just bring it to a b&m and see if they are willing to buy it.

Tell them its plume!
[Reply]
loki 02:27 PM 11-02-2008
Originally Posted by NCRadioMan:
Could it have always been there and you just missed it, Kevin? Mold cannot grow at those rh %'s.
its possible thats its been there a while i dont dig to the bottom of that humi all that often but my beads spilled and i had to clean the up and there it was fluffy whiteness on the foot. my beads are 65 but i like to keep the humi closer to 60. the odd thing is that it was only on the foot and not under the ceader wraper at all. ive pulled that set out of the humi
[Reply]
brigey57 04:04 PM 11-02-2008
Originally Posted by Sauer Grapes:
I can. Also, different kinds of tobacco mold more easily than other kinds. I know that CT Broadleaf Maduro wrappers mold about the easiest.
:-)I agree. I have had one cigar mold a while back. Never smoked it, but I have wondered what would be the consequences if I had??? :-):-)
[Reply]
TOB9595 04:39 PM 11-02-2008
can you clip/smoke a cigar with a moldy foot?

I once did it with crabs...
Does that count?

hahahahaha

Tom
[Reply]
Pyro 04:22 AM 11-03-2008
Originally Posted by Da Klugs:
I microwave them to make sure nuttin is growing in the cigar or in me when I smoke it.
We are exposed to spores all the time, we inhale spores in every breath we take! This kind of mold will not grow on people and the amount of spores inhaled is so negligible that I have a hard time believing that exposure from an occasional mouldy cigar could have any additional health effects compared to what's already in the smoke.

Just my 50 öre (about 7 cents today :-) )
[Reply]
Up