I have an Edgestar 28 bottle Fridgador that I love. But I think it may have a slight leak... and I'm thinking it's the drain plug. I think i just have a piece paper towel shoved in the drain hole right now... far from perfect.

So, what are some of you using to fill this drain hole in your Fridgadors??

Thanks!
[Reply]

Covered both my vino drains with black duct tape
[Reply]

I've heard of people using pretty much anything. From tape to screws and now paper towels.

I would think tape would be sufficient, but in reality, having the opening is probably not a huge issue.

I haven't plugged mine and my RH stays pretty constant between 65-70.

Try some tape, electrical or duct should work just fine and see if you notice any differences.
[Reply]

Have you check out the Accessory Reviews section? It tends to have something in there. I believe someone did one up one time with pics
[Reply]

I use Electrical Putty and then re route the condensation to a bowl on the bottom of the Edgestar by one of those binder dividers.

There are many different ways to do this depends on how your fridge is setup I guess.
[Reply]

You can also check out what Scott did and modify it as you see fit

Linky
[Reply]

Arc weld it.
[Reply]

Sure did. :-)
[Reply]

solder the hole shut then get some small screws and sheet metal to cover that up . :-)
[Reply]

I used electrical putty as well.
[Reply]

Electrical putty is the best I ever found. :-)
[Reply]

Black electrical tape.
[Reply]

Thanks guys... I'll probably try electrical tape, since I have that handy.... and see how that goes.
[Reply]

Use a Gurkha... any one will do
[Reply]

Dont do that, the cooler will spit it out!!!:-):-)
[Reply]

I thought u only had pink Bob? :-)
Posted via Mobile Device
[Reply]

:-) I had to go to Home Depot to get the other stuff!
[Reply]